REPLACING ALTERNATOR BRUSHES + VIDEO INSTRUCTIONS on a PEUGEOT 206.
I personally have to 280000 km run stočilis′ brushes of the generator and battery missing. It is safe to say that more than 300000 km without repair of the generator to the Peugeot 206 sedan is not to drive and you should be ready for it. The first signs of:-your computer manifests the inscription: loss of control, and the measurements of the device not charging, then check the battery starts to burn continuously, warning that lost charge. Proceed to disassembly. To get to the generator, you must: 1) remove the ručejkovyj belt, power generator, power steering and air conditioning, 2) remove the power steering fluid, otsosav, 3) will have to unprotect the exhaust manifold, one look at the State of the collector (I personally have a crack), 4) Remove the generator directly. Lifting the generator to its disassembly. Unscrew the top cap with relay charging and brushes. Next, look at the appearance, if it was filled with hydraulic fluid and is in a very dirty state (as in my case), you will need to contact raspaât′ diode bridge and rinse well with the stator and the rotor. If not, the electric appliance checks the status of the winding and checks the rectifier and if all is well, then you should not disassemble and proceed with replacement brushes. Brushes can be bought as original (they go along with cover and switch the charging cost about $ 40-$ 50). And you can buy from the cheapest model-in my case it's brushes with VAZ 2109 (Russia) and cost $ 1-only it came to length. The next stage: vypaivaem old brush, the ends of the brushes-where brazing (need to whittle away a file almost completely for easy drinking) or unsolder is problematic because of the trapecividnoj forms the tip of the spring. New brushes will have to be chiseled away at the lime across the width and along the length of the fully fit and vpaivaem in place of the old. Next, review the State of the bearings and krutâŝej axis, where are those brass-sections need to be sanded and proceed to Assembly. Next, look at the photo and video-this will create a complete picture of the description!